Personal Computer User Manual
Table Of Contents
- Dell OptiPlex 9020 AIO Owner's Manual
- Working on Your Computer
- Removing and Installing Components
- System Overview
- Removing the VESA Stand
- Installing the VESA Stand
- Removing the Back Cover
- Installing the Back Cover
- Removing the Memory
- Installing the Memory
- Removing the VESA Mount Bracket
- Installing the VESA Mount Bracket
- Removing the Power and On-Screen Display (OSD) Buttons Board
- Installing the Power and OSD Buttons Board
- Removing the System-Board Shield
- Installing the System-Board Shield
- Removing the Converter Board
- Installing the Converter Board
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the Optical Drive
- Installing the Optical Drive
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the Intrusion Switch
- Installing the Intrusion Switch
- Removing the Wireless Local Area Network (WLAN) Card
- Installing the WLAN Card
- Removing the Heat-Sink Assembly
- Installing the Heat-Sink Assembly
- Removing the Processor Fan
- Installing the Processor Fan
- Removing the Power-Supply Fan
- Installing the Power-Supply Fan
- Removing the I/O Board Shield
- Installing the I/O Board Shield
- Removing the Power Supply Unit (PSU)
- Installing the Power Supply Unit
- Removing the Processor
- Installing the Processor
- Removing the Speakers
- Installing the Speakers
- Removing the System Board
- System Board Layout
- Installing the System Board
- Removing the Heat Sink (Graphics Card)
- Installing the Heat Sink (Graphics Card)
- Removing the Antenna Module
- Installing the Antenna Module
- Removing the Display Panel
- Installing the Display Panel
- Removing the Camera
- Installing the Camera
- System Setup
- Technical Specifications
- Contacting Dell
CAUTION: Before touching anything inside your computer, ground yourself by touching an unpainted metal
surface, such as the metal at the back of the computer. While you work, periodically touch an unpainted metal
surface to dissipate static electricity, which could harm internal components.
Recommended Tools
The procedures in this document may require the following tools:
• Small flat-blade screwdriver
• Phillips screwdriver
• Small plastic scribe
Turning Off Your Computer
CAUTION: To avoid losing data, save and close all open files and exit all open programs before you turn off your
computer.
1. Shut down the operating system:
– In Windows 8:
* Using a touch-enabled device:
a. Swipe in from the right edge of the screen, opening the Charms menu and select Settings.
b. Select the and then select Shut down
* Using a mouse:
a. Point to upper-right corner of the screen and click Settings.
b. Click the and select Shut down.
– In Windows 7:
1. Click Start .
2. Click Shut Down.
or
1. Click Start .
2. Click the arrow in the lower-right corner of the Start menu as shown below, and then click Shut
Down..
2. Ensure that the computer and all attached devices are turned off. If your computer and attached devices did not
automatically turn off when you shut down your operating system, press and hold the power button for about 6
seconds to turn them off.
6