User Manual
Table Of Contents
- Dell Precision 5820 Tower Owner's Manual
- Working on your computer
- Removing and installing components
- Screw size list
- Recommended tools
- Side cover
- Power supply unit (PSU)
- Front bezel
- Hard Disk Drive bezel
- Hard disk drive assembly
- Slim Optical Disk Drive
- Front input and output bezel
- Optical Disk Drive
- 5.25 inch ODD bracket
- Front input and output panel
- Input and output panel bracket
- Intruder switch
- Internal chassis speaker
- Air shroud
- Memory
- Expansion card
- Coin cell battery
- System fan
- Fan bracket
- PCIe holder
- Heat sink and CPU fan assembly
- Processor
- Front system fan
- System board
- Technology and components
- System specifications
- System Setup
- Software
- Troubleshooting
- Contacting Dell
Installing the internal chassis speaker
1 Press and hold the tabs on either side of the intrusion speaker, and slide the speaker module into the slot to secure it to the system.
2 Connect the internal chassis speaker cable to the connector on the system chassis.
3 Install the:
a 5.25 inch ODD bracket
b front bezel
c side cover
4 Follow the procedure in After working inside your computer
Air shroud
Removing the air shroud
1 Follow the procedure in Before working inside your computer.
2 Remove the side cover
3 To remove the air shroud:
a Press in the securing tabs by holding the air shroud from both the ends, and then lift the air shroud from the system.
Removing and installing components
35