Owner's Manual

5. Run the setup_afc.sh file.

6. Enter the IP address for the MongoDB server followed by a comma, then enter the IP address of the

secondary server.

7. Enter true to enable HA.

8. Update the AFC values or press Enter to continue the installation.

9. Configure the AFC controller IP address and credentials in OpenStack.

10. Update the multicast values or press Enter to continue the installation.

NOTE: The primary and secondary nodes must use the same multicast address, which cannot

be used for any other HA configuration.

11. Enter true to enable BMP. To disable BMP, enter false.

12. Enter the netmask DHCP IP range.

13. Press Enter to update the listed IP addresses.

Upgrading RPM-Installed Software