Users Guide

Based on the component type, specific settings and properties appear automatically that are

required and can be edited. For more information specific to component type settings, see

Component Types.

When you redeploy an existing service after adding one or more servers, the following states are

displayed in the Resources page:

• The state of the existing server resources that are part of the service changes from “Deployed” to

‘Deploying”, and then changes to “Deployed” after the deployment is complete.

• The state of the new server changes from “Available” to “Reserved”. Once the deployment starts, the

state changes to “Deploying”. If the deployment is successful, the state changes to “Deployed”. If the

deployment is not successful, the state changes to “Error”.

Adding storage to existing service

To add storage components to an existing service:

1. On the Add Storage page, add the storage to the service in one of the following ways:

• If you want to clone an existing storage configuration to the storage that you want to add to the

service, next to New Component Settings, click Duplicate, and perform the following steps:

1. From the Resource to Duplicate drop down list, select a storage component.

2. In the # of Instances box, enter the number of storage instances that you want to add to the

service. Click Continue.

3. In the Component Name box, enter the storage name for the corresponding components.

4. In the Storage Volume box, enter the volume name in the storage.

• If you want to add new server component, next to New Component Settings. click New, and

perform the following steps:

1. From the Select a Component drop-down list, select one of the following storage

components:

– Compellent

– EqualLogic

– NetApp

2. Under Associated Resources, to associate the newly added storage component to the

existing components in the service, select the components to associate.

3. Click Continue.

Based on the component type, specific settings and properties appear automatically that are

required and can be edited. For more information specific component type settings, see

Component Types.

2. Click Save.