Users Guide

Field Name Description

then this flag is ignored. If this flag is present, then the Port Type must also

be specified. The possible values are true or false.

Force Map If the value of this property is defined, it forces mapping, even if the

mapping already exists. The possible values are true or false.

Map Read Only Specifies whether or not a map is read-only. The possible values are true

or false.

Single Path Map Specifies that only a single local port can be used for mapping. If omitted,

all local ports are used for mapping. The possible values are true and false.

Configure SAN Switch Enables the zone configuration on the Brocade FC SAN switch.

NetApp Storage Settings

Target NetApp * Specifies the NetApp storage device where the volume will be created.

Storage Volume * Select the volume name on the NetApp array. To create a new volume,

from the Storage Volume drop-down list, select Create New Volume.

New volume name Enter the name of the volume that is to be created or destroyed. The

storage volume names created on same aggregate must be unique in a

NetApp storage array.

Storage Size e.g 100GB * Specifies the volume size. Enter the number of 512-byte blocks or the total

byte size. You can specify the total byte size in the following formats: MB

for megabytes, GB for gigabytes, or TB for terabytes. The volume size must

be between 20 MB and 999 TB.

Aggregate Name * Specifies the aggregate name on which the volume is created.

The space reservation

mode

Specifies the type of volume that guarantee the new volume will use.

Possible values: none, File, Volume. If any value is not selected, the default

volume guarantee type is set to Volume.

The percentage of space to

reserve for snapshots *

Specifies the percentage of space to reserve the snapshots. Default value is

Auto increment Select this check box to enable auto-increment of volume size. By default,

auto increment is enabled.

Persistent

• In Data ONTAP 7-Mode, the persistent is enabled by default. If it is

enabled, modifies the etc/exports file to append the rule for a

permanent change. (The new rule still takes effect immediately.)

• In Data ONTAP Cluster-Mode, the export entries are always persistent.

Persistent is enabled by default. If persistent is not enabled an error

occurs.

NFS Target IP Specifies the interface IP that is used for NFS traffic in your environment.