Users Guide
Configuring default firmware repository
On the Default Firmware Repository page, you can:
• Click Add Repository to create new firmware repositories.
• Click Remove to remove a repository
• Click View Details to view the firmware bundles that are available in the firmware repository.
• Select a repository from the list and click Set as Default to set the repository as default firmware
repository.
Running firmware compliance
ASM requires a minimum firmware level for all resources it manages.
The Firmware Compliance page list the resources that do not meet the firmware requirements specified
in the default repository that you have set in the previous step.
On this page, select the resources that you want to update the firmware automatically, click Next.
If you skip the automatic firmware update, in the Resources → Resources tab, the Firmware Compliance
state of the resources that is not compliant is displayed as either Update Required or Non-Compliant .
Configuring global chassis settings
1. On the Chassis Configuration page of the Configure Chassis wizard, select one or more chassis that
you want to configure.
2. Under Select Chassis for Initial Configuration, select the one or more chassis that you want to
configure.
3. Under Global Settings, in the Users section, configure additional CMC and iDRAC local users.
a. To add new Chassis Management Controller (CMC) user, under CMC Users, click Create. For
more information, see Adding or Editing a Chassis Management Controller (CMC) User.
To edit a user account, select a CMC user from the list, and click Edit. To delete a user account,
select the user accounts from the list, and click Delete.
b. To add new Integrated Dell Remote Access Controller (iDRAC) user, under iDRAC Users, click
Create. For more information, see Adding Or Editing An Integrated Dell Remote Access
Controller (iDRAC) User.
4. Under Global Settings, in the Monitoring section, configure the following settings:
a. To set SNMP trap alert destination, perform the following steps:
1. Under Alert Destinations, to add an SNMP trap alert destination for chassis, click Create.
To edit Alert Destinations, select an alert destination from the list, and click Edit. To delete
an alert destination, select an alert destination from the list, and click Delete.
2. Enter a valid Destination IP Address. Use the quad-dot IPv4 format (for example,
10.10.10.10) or Fully Qualified Domain Name (for example, dell.com).
98