Owner's Manual

6. Click

Publish Template.

This template is now ready to be deployed.

Template – Deploy Hyper-V Cluster with iSCSI Storage

The

Deploy Hyper-V Cluster with iSCSI Storage template deploys two iSCSI storage volumes and installs

Hyper-V on a physical host.

To deploy Hyper-V host with iSCSI storage using this template, perform the following steps:

1. On the

Templates page, select the Deploy Hyper-V Cluster with iSCSI Storage template, and click

Clone.

2. In the

Create Template dialog box, enter a name, description, category for the template, and click

Save.

3. On the

Template Builder page, click each storage components, click Edit in the box that is displayed,

and configure the following settings in the Storage Component dialog box.

a. Modify the Component Name with a unique name, if required.

b. Under Storage Settings, configure the following:

1. Select your Target EqualLogic iSCSI array.

2. Enter the Storage Volume Name if required.

NOTE

: Make sure that you enter the storage size for the first volume is large enough

to support your Hyper-V host storage. However, the storage size for the second

volume can be small because it is configured as a quorum volume if this host will be

used for a Hyper-V cluster. The recommended second volume size is 512MB.

c. Verify the values for Storage Pool, Thin Provisioning, Snapshot Reserve %, Thin Min Reserve %,

Thin growth Warning %, Thin growth Maximum %, Thin warning on threshold %, Thin warning

on hard threshold %, and Multi-Host access of volume.

d. Click Save.