Owner's Manual
4. To make changes to a filter, click the filter and then click Edit. Make the changes, and then click OK.
To remove a filter, click the filter and then click Remove.
5. For information about the settings on the General and Run Behavior tabs, see Common Configuration Instructions
for All Activities .
6. Click Finish.
Configuring the Filters Tab
1. In the Configuration section, click the ellipsis button (...), and select the Dell AIM Object configuration that you want
to use for this activity. Click OK.
2. In the Filters section click Add. In the Name field, click the down arrow and select a property from the list.
3. In the Relation field, click the down arrow and select a filter type.
4. In the Value field, enter the value you want to use.
You can also use returned data to automatically populate the value of the property from the data output by a
previous activity in the workflow. For more information see Filters Tab .
Using Returned Data — Configuring the Filters Tab
Add additional filters as needed, and then click Finish.
1. Right-click the property value field, click Subscribe, and then click Returned Data.
2. Click the Activity drop-down and select the activity from which you want to obtain the data.
3. To view additional data elements common across the runbook, select Show Common Returned Data.
4. Click the returned data element you want to use, and then click OK.
For a list of the data elements published by each activity, see the Returned Data tables in the activity topic.
5. Click OK to save the filter settings.
Configuring the Remove Object Activity
To configure the Remove Object activity:
1. From the Activities pane, drag a Remove Object activity to the active runbook.
2. Double-click the Remove Object activity.
The Properties dialog box is displayed.
3. Configure the Properties tab, for more information see Configure the Properties tab.
4. For information about the settings on the General and Run Behavior tabs, see Common Configuration Instructions
for All Activities .
5. Click Finish.
Configuring the Update Object Activity
To configure the Update Object activity:
1. From the Activities pane, drag an Update Object activity to the active policy.
2. Double-click the Update Object activity.
The Properties dialog box is displayed.
3. Configure the Properties tab. For more information see Configure the Properties tab.
36