Manual

84 | Replacing the Logo Board
Replacing the Logo Board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
"Before You Begin" on page 9. After working inside your computer,
follow the instructions in "After Working Inside Your Computer" on
page 11. For additional safety best practices information, see
the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.
Procedure
1 Connect the display-light board cables, logo-board cable and display cable to the
logo-board connectors.
2 Carefully rotate the logo board over and align the screw holes on the logo board with
the screw holes on the display back-cover.
3 Replace the screws that secure the logo board to the display back-cover.
Postrequisites
1 Replace the display panel. See "Replacing the Display Panel" on page 78.
2 Replace the display hinges. See "Replacing the Display Hinges" on page 74.
3 Replace the display bezel. See "Replacing the Display Bezel" on page 72.
4 Replace the display assembly. See "Replacing the Display Assembly" on page 70.
5 Follow the instructions from step 5 to step 10 in "Replacing the Palm Rest" on
page 36.
6 Follow the instructions from step 8 to step 10 in "Replacing the Secondary Hard-Drive
(optional)" on page 22.
7 Replace the battery. See "Replacing the Battery" on page 15.
8 Replace the base cover. See "Replacing the Base Cover" on page 13.
9 Follow the instructions in "After Working Inside Your Computer" on page 11.
book.book Page 84 Monday, June 24, 2013 10:53 AM