Service Manual

Removing the logo board

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the

steps in Before working inside your computer. After working inside your computer, follow the instructions in After working

inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/

regulatory_compliance.

Prerequisites

1. Remove the

base cover.

2. Remove the wireless card.

3. Remove the solid-state drive.

4. Remove the rear-I/O cover.

5. Remove the

computer base.

6. Remove the memory modules.

7. Remove the display assembly.

8. Remove the display bezel.

Procedure

1. Remove the two screws (M2x3) that secure the logo board to the display back-cover and antenna assembly.

2. Turn the logo board over.

3. Disconnect the tron-light cable from the logo board.

4. Pull the latch that secures the Alienhead cable to the logo board.

5. Disconnect the Alienhead cable from the logo board.

6. Disconnect the logo-board cable from the logo board.

7. Disconnect the tron-light cable from the logo board.

8. Lift the logo board off the display back-cover and antenna assembly.