Service Manual

Removing the display back-cover and antenna

assembly

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the

steps in Before working inside your computer. After working inside your computer, follow the instructions in After working

inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/

regulatory_compliance.

Prerequisites

1. Remove the

base cover.

2. Remove the

wireless card.

3. Remove the solid-state drive.

4. Remove the rear-I/O cover.

5. Remove the computer base.

6. Remove the battery.

7. Remove the

memory modules.

8. Remove the display assembly.

9. Remove the display bezel.

10.Remove the camera.

11. Remove the

logo board.

12. Remove the display panel.

13. Remove the display hinges.

Procedure

1. Peel off the display cable, logo-board cable, and camera cable from the display back-cover and antenna assembly.

2. After performing all the above steps, you are left with the display back-cover and antenna assembly.