Users Guide

34 | Setting up the monitor
2. Connect
the other end of the USB 3.2 Gen1 upstream cable to an
appropriate USB 3.2 Gen1 port on your computer.
3. Connect
the USB 3.2 Gen1 peripherals to the USB 3.2 Gen1 downstream
ports on the monitor.
4. Plug the
power cables for your computer and monitor into a wall outlet.
5. T
urn on the monitor and the computer.
If your monitor displays an image, installation is complete. If it does not
disp
lay an image, see Common problems.
Removing the monitor stand
NOTE: To prevent scratches on the display when removing the stand,
ensure that the monitor is placed on a soft, clean surface.
NOTE: The following instructions are applicable only for attaching the
stand that was shipped with your monitor. If you are attaching a stand
that you purchased from any other source, follow the set up instructions
that were included with the stand.
To remove the stand:
1. Tur
n off the monitor.
2. Disconnect the cabl
es from the computer.
3. Plac
e the monitor on a soft cloth or cushion.
4. C
arefully slide and remove the I/O cover from the monitor.