Service Manual

Advanced
BIOS Auto-Recovery Enable the user to recover from certain corrupted BIOS conditions
from a recovery file on the user primary hard drive. Default:
Disabled.
Always Perform Integrity Check Allows you to perform the Integrity check. Default: Disabled.
CPU configuration
Hyper-threading Technology Enable or disable HyperThreading in the processor. Default:
Enabled.
Intel (R) SpeedStep (tm) Enable or disable Intel Speedstep Technology. Default: Enabled.
NOTE: If enabled, the processor clock speed and core
voltage are adjusted dynamically based on the processor
load.
Virtualization Allows you to enable or disable the Intel Virtualization technology.
Default: Enabled
VT for Direct I/O Specify whether a Virtual Machine Monitor (VMM) can utilize the
additional hardware capabilities provided by Intel Virtualization
Technology for Direct I/O. Default: Enabled.
Active Processor Cores
Integrated Devices
Front USB Port Allows you to enable or disable the front USB ports. Default:
Enabled.
Rear USB Port Allows you to enable or disable the rear USB ports. Default:
Enabled.
ASMedia XHC Controller Allows you to enable or disable the XHC controller. Default:
Enabled.
HD Audio Allows you to enable or disable the integrated audio controller.
Default: Enabled.
Integrated NIC1 Allows you to enable or disable the NIC1. Default: Enabled.
Integrated NIC2 Allows you to enable or disable the NIC2. Default: Enabled.
Pxe Option Allows you to enable or disable the boot option for legacy network
devices. Default: Disabled.
SATA Mode Allows you to configure the operating mode of the integrated
SATA hard drive controller.
Default: Inte Smart Response Technology.
PCIE GEN3 Allows you to enable or disable the PCIE GEN3. Default:
Disabled.
Power Management Setup
AC Recovery Sets what action the computer takes when power is restored.
Default: Last State.
Deep Sleep Control Allows you to define the controls when Deep Sleep is enabled.
Default: Enabled in S5 Only.
Auto Power On Enable to set the computer to turn on automatically every day or
on a preselected date and time. This option can be configured only
if the Auto On Time is set to Everyday, Weekdays, or Selected
Days.
Default: Disabled.
Numlock Key Enable or disable Numlock.
Default: Enable Numlock.
114