Service Manual

Removing the logo board

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the

steps in Before working inside your computer. After working inside your computer, follow the instructions in After working

inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/

regulatory_compliance.

Prerequisites

1. Remove the

stability foot.

2. Remove the left and right side-panels. See “Removing the side panels”.

3. Remove the top fan.

Procedure

NOTE: Note the routing of all cables as you remove them so that you can route them correctly after you replace the logo

board.

1. Disconnect all the cables from the logo board.

2. Remove the screw (#6-32x6) that secures the logo board to the chassis.

3. Slide the logo board out of the chassis.