Service Manual

Removing the front bezel

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the

steps in Before working inside your computer. After working inside your computer, follow the instructions in After working

inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/

regulatory_compliance.

Prerequisites

1. Remove the

stability foot.

2. Remove the left and right side-panels. See “Removing the side panels”.

3. Remove the handle bars.

Procedure

1. Pull the connector downwards and then disconnect the top tron light-cables from the front bezel.

2. Pull the connector downwards and then disconnect the bottom tron light-cables from the front bezel.

3. Remove the two screws (6-32x5.2) from inside, securing the front bezel to the left side of the chassis.

4. Remove the screw (6-32x5.2) from inside, securing the front bezel to the right side of the chassis.

5. Release the tabs from inside the chassis on the right side, securing the front bezel to the chassis.

6. Pull the front bezel off the chassis.