Service Manual

Steps

1. Disconnect the data and power cables from the hard drive.

2. Press the release tabs on the hard-drive carrier and slide the hard-drive carrier out of the hard-drive cage.

3. Pry the hard-drive carrier to release the tabs on the carrier from the slots on the hard drive.

4. Lift the hard drive out of the hard-drive assembly.

NOTE: Note the orientation of the hard drive so that you can replace it correctly.

Installing the 3.5-inch hard drive

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the 3.5-inch hard drive and provides a visual representation of the installation

procedure.