Service Manual
Table Of Contents
- Alienware Aurora R12 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Inside view of your computer
- System-board components
- Recommended tools
- Screw list
- Left-side cover
- Top cover
- Right-side cover
- Right tron-light board
- 2.5-inch hard drive
- 3.5-inch hard drive
- 2.5-inch hard-drive cage
- 3.5-inch hard-drive cage
- 550 W power-supply unit
- 1000 W Power-supply unit
- Coin-cell battery
- Memory modules
- Single-graphics card
- Solid-state drive
- Front bezel
- Top bezel
- Bottom cover
- Processor fan and heat-sink assembly
- Processor liquid-cooling assembly
- Processor
- Wireless card
- Antennas
- Front I/O-panel
- Front-chassis fan
- Top-chassis fan
- Front AlienFX LED boards
- Power-button board
- System board
- Device drivers
- System setup
- Troubleshooting
Steps
1. Disconnect the tron-light cable.
2. Remove the four screws (#6-32) that secure the right tron-light board to the chassis.
3. Remove the right tron-light board off the chassis.
Installing the right tron-light board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the right tron-light board and provides a visual representation of the installation
procedure.
19