Service Manual
Table Of Contents
- Alienware Aurora R12 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Inside view of your computer
- System-board components
- Recommended tools
- Screw list
- Left-side cover
- Top cover
- Right-side cover
- Right tron-light board
- 2.5-inch hard drive
- 3.5-inch hard drive
- 2.5-inch hard-drive cage
- 3.5-inch hard-drive cage
- 550 W power-supply unit
- 1000 W Power-supply unit
- Coin-cell battery
- Memory modules
- Single-graphics card
- Solid-state drive
- Front bezel
- Top bezel
- Bottom cover
- Processor fan and heat-sink assembly
- Processor liquid-cooling assembly
- Processor
- Wireless card
- Antennas
- Front I/O-panel
- Front-chassis fan
- Top-chassis fan
- Front AlienFX LED boards
- Power-button board
- System board
- Device drivers
- System setup
- Troubleshooting
Processor fan and heat-sink assembly
Removing the processor fan and heat-sink assembly
Prerequisites
1. Follow the procedure in
Before working inside your computer.
NOTE: The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you
touch it.
CAUTION: For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The oils in your
skin can reduce the heat transfer capability of the thermal grease.
2. Remove the left-side cover.
About this task
The following images indicate the location of the processor fan and heat-sink assembly and provides a visual representation of the
removal procedure.
62