User Manual

Replacing the Front Bezel



1. Follow the instructions in Before You Begin.



2. Align the front bezel with the front of the chassis.



3. Replace the three screws on the right side that secure the front bezel to the chassis.



4. Lay the chassis on its side.



5. Route and connect the front-bezel cables to the connectors on the master I/O board.



6. Replace the seven screws that secure the front bezel to the chassis.



7. Replace the right-side bottom panel (see Replacing the Right-Side Bottom Panel).



8. Replace the right-side middle panel (see Replacing the Right-Side Middle Panel).



9. Replace the lighting board (see Replacing the Lighting Board).



10. Replace the right-side top panel (see Replacing the Right-Side Top Panel).



11. Replace the drive-bay shroud (see Replacing the Drive-Bay Shroud).



12. Close the PCI shroud (see Closing the PCI Shroud).



13. Replace the left side-panel (see Replacing the Left Side-Panel).



14. Connect your computer and all attached devices to electrical outlets, and turn them on.

Back to Contents Page



front bezel

screws (3)

CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may

result in damage to the computer.