Service Manual

Replacing the Right-Side Top Panel



1. Follow the instructions in Before You Begin.



2. Align the tabs on the right-side top panel with the slots on the chassis and slide the panel into position.



3. Lay the computer on its side.



4. Replace the screw that secures the right side-panel.



5. Replace the drive-bay shroud (see Replacing the Drive-Bay Shroud).



6. Close the PCI shroud (see Closing the PCI Shroud).



7. Replace the left side-panel (see Replacing the Left Side-Panel).



8. Connect your computer and all attached devices to electrical outlets, and turn them on.

Removing the Lighting Board



1. Follow the instructions in Before You Begin.



2. Remove the right-side top panel (see Removing the Right-Side Top Panel).



3. Disconnect the lighting-board cable from the connector on the master I/O board.



4. Make a note of the lighting-board cable routing and remove it from the slot on the computer.



5. Remove the three screws that secure the lighting board to the right-side middle panel.



6. Lift the lighting board along with its cable away from the right-side middle panel.

right-side top panel

CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may

result in damage to the computer.