Service Manual

Steps

1. Place the battery on the palm-rest assembly.

2. Align the screw holes on the batery to the screw holes on the palm-rest assembly.

3. Replace the four screws (M2x4) that secure the battery to the palm-rest assembly.

4. Replace the four screws (M2x3) that secure the battery to the palm-rest assembly.

Next steps

1. Install the base cover.

2. Follow the procedure in After working inside your computer.

M.2 solid-state drive

Removing the M.2 2230 solid-state drive

Prerequisites

1. Follow the procedure in Before working inside your computer.

2. Remove the

base cover.

About this task

NOTE: This procedure applies only to computers shipped with a M.2 2230 solid-state drive installed in the following M.2

card slots:

• M.2 card slot 1

• M.2 card slot 2

The following image(s) indicate the location of the M.2 2230 solid-state drive and provides a visual representation of the removal

procedure.