Service Manual

Steps

1. Align the notch on the M.2 2230 WWAN/solid-state drive with the tab on the M.2 card slot on the left I/O-board.

2. Slide the M.2 2230 WWAN/solid-state drive into the M.2 card slot on the left I/O-board.

3. Place the M.2 2230 thermal shield on the M.2 2230 WWAN/solid-state drive.

4. Align the screw hole on the M.2 2230 thermal shield with the screw hole on the left I/O-board.

5. Replace the screw (M2x2.5) that secures the M.2 2230 WWAN/solid-state drive and thermal shield to the left I/O-board.

Next steps

1. Install the

base cover.

2. Follow the procedure in After working inside your computer.

Rear-I/O cover

Removing the rear I/O-cover

Prerequisites

1. Follow the procedure in Before working inside your computer.

2. Remove the base cover.

About this task

The following image(s) indicate the location of the rear I/O-cover and provides a visual representation of the removal procedure.