Service Manual

Steps

1. Using the alignment posts, place the left speaker on the palm-rest assembly.

NOTE: Ensure that the alignment posts are threaded through the rubber grommets on the speaker.

2. Route the speaker cable through the routing guides on the palm-rest assembly.

3. Using the alignment posts, place the right speaker on the palm-rest assembly.

NOTE: Ensure that the alignment posts are threaded through the rubber grommets on the speaker.

4. Connect the speaker cable to the right I/O-board.

Next steps

1. Install the

battery.

2. Install the base cover.

3. Follow the procedure in After working inside your computer.

Touchpad

Removing the touchpad

Prerequisites

1. Follow the procedure in Before working inside your computer.

2. Remove the base cover.

3. Remove the battery.

About this task

The following image(s) indicate the location of the touchpad and provides a visual representation of the removal procedure.