Service Manual

Steps

1. Peel and lift the Mylar covering the system board.

2. Disconnect the speaker cable from the right I/O-board.

3. Remove the two screws (M2x3) that secure the right I/O-board cable connecting the right I/O-board and the system board.

4. Lift the right I/O-board cable off the right I/O-board and system board.

5. Remove the two screws (M2x3) that secure the right I/O-board to the palm-rest assembly.

6. Lift the right I/O-board off the palm-rest assembly.

Installing the right I/O-board

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the right I/O-board and provides a visual representation of the installation procedure.