Service Manual

Steps

1. Place the power-adapter port into the slot on the palm-rest assembly.

2. Place the power-adapter port bracket on the power-adapter port.

3. Align the screw holes on the power-adapter port bracket to the screw holes on the palm-rest assembly.

4. Replace the two screws (M2x3) that secure the power-adapter port bracket to the palm-rest assembly.

Next steps

1. Follow the procedure from step 3 to step 24 in

Installing the system board.

2. Install the right IO-board.

3. Install the rear IO-cover.

4. Install the M.2 2230 solid-state drive. (if applicable)

5. Install the

M.2 2280 solid-state drive. (if applicable)

6. Install the battery.

7. Install the base cover.

8. Follow the procedure in After working inside your computer.

Power-button assembly

Removing the power-button assembly

Prerequisites

1. Follow the procedure in Before working inside your computer.

2. Remove the base cover.

3. Remove the battery.

4. Remove the M.2 2230 solid-state drive. (if applicable)

5. Remove the M.2 2280 solid-state drive. (if applicable)

6. Remove the

rear IO-cover.

7. Remove the right IO-board.

8. Follow the procedure from step 1 to step 19 in Removing the system board.