Service Manual
Table Of Contents
- Alienware m15 Ryzen Edition R5 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Alienware m15 Ryzen Edition R5
- Base cover
- Battery
- Solid-state drive
- Removing the 2230 solid-state drive in SSD slot one
- Installing the 2230 solid-state drive in SSD slot one
- Removing the 2280 solid-state drive in SSD slot one
- Installing the 2280 solid-state drive in SSD slot one
- Removing the 2230 solid-state drive in SSD slot two
- Installing the 2230 solid-state drive in SSD slot two
- Removing the 2280 solid-state drive in SSD slot two
- Installing the 2280 solid-state drive in SSD slot two
- Procedure to move the screw mount in SSD slot one
- Procedure to move the screw mount in SSD slot two
- Speakers
- I/O board
- Memory module
- Wireless card
- Rear-I/O cover
- Touchpad
- Power-adapter port
- Display assembly
- Keyboard-controller board
- System board
- Heat-sink assembly
- USB board
- Power button
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Alienware
Steps
1. Disconnect the left and right fan cables from the system board.
2. Turn the system-board assembly over.
3. Remove the six screws (M2x4) that secure the heat-sink assembly to the system board.
4. Lift the heat-sink assembly off the system board.
Installing the heat-sink assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the heat-sink assembly and provides a visual representation of the installation
procedure.
CAUTION: Incorrect alignment of the heat sink can damage the system board and processor.
59