Service Manual

3 Remove the screw (M2x3) that secures the M.2 2230 solid-state drive bracket to the palm-rest assembly.

4 Slide and remove the M.2 2230 solid-state drive along with the bracket from the M.2 slot on the system board.

5 Remove the screw (M1.6x2) that secures M.2 2230 solid-state drive to the solid-state drive bracket.

6 Lift the M.2 2230 card o the solid-state drive bracket.

Procedure to remove M.2 2280 solid-state drive

NOTE: This procedure applies only to systems shipped with a M.2 2280 solid-state drive installed.

NOTE: Depending on the conguration ordered the system may have up to two M.2 solid-state drives installed.

Supported solid-state drive congurations per M.2 solid-state drive slot:

• M.2 2230 solid-state drive + solid-state drive bracket

• M.2 2280 solid-state drive

• M.2 2280 Intel Optane

NOTE: For solid-state drives above 512 GB or Intel Optane above 118 GB a thermal shield is required for optimal

heat dissipation and is installed in the computer when these congurations are ordered. If these congurations are

installed After Point-of-Sale (APOS), contact Dell support for the thermal shield.

NOTE: Depending on the number of M.2 solid-state drives installed at Point-of-Sale, the thermal shield installed in

the computer may be a full shield or a half shield. If two M.2 solid-state drives are installed After Point-of-Sale

(APOS) contact Dell support for the full thermal shield.

1 Remove the two screws (M2x3) that secure the M.2 thermal shield to the palm-rest assembly and system board.