Service Manual

Replacing the speakers
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in Before working inside your computer. After working inside your computer, follow the instructions
in
After working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
NOTE: If the rubber grommets are pushed out of the speakers when removing the speakers, push them back in place
before replacing the speakers.
1 Using the alignment posts and rubber grommets, place the speakers in the slots on the palm-rest assembly.
2 Route the speaker cable through the routing guides on the palm-rest assembly.
3 Connect the speaker cable to the system board.
Post-requisites
1 Replace the system board.
2 Replace the I/O board.
3 Follow the procedure from step 4 to step 6 in Replacing the hard drive.
4 Replace the battery (half-length) or the battery (full-length), whichever applicable.
5 Replace the base cover.
63