Service Manual
Table Of Contents
- Alienware m17 R4 Service Manual
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Alienware m17 R4
- Base cover
- Solid state drive—M.2 slot one
- Solid state drive—M.2 slot two
- Solid state drive—M.2 slot three
- Battery
- Speakers
- Keyboard-controller board
- Touchpad
- Rear-I/O cover
- Display assembly
- Right I/O-board
- System board
- Left I/O-board
- Fan and heat-sink assembly
- Power-adapter port
- Power-button assembly
- Keyboard
- Palmrest
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Alienware
Steps
1. Place and align the M.2 2230 mounting bracket on the palm-rest assembly.
2. Replace the screw (M2x3) that secures the M.2 2230 mounting bracket to the palm-rest assembly.
3. Align the notch on the M.2 2230 solid-state drive with the tab on the M.2 card slot on the system board.
4. Slide the M.2 2230 solid-state drive into the M.2 card slot on the system board.
5. Slide the solid-state drive thermal shield on the M.2 2230 solid-state drive.
NOTE: The next step is only applicable if the capacity of the solid-state drive is 512 GB or higher.
6. Replace the two screws (M2x3) that secure the M.2 2230 solid-state drive and the solid-state drive thermal shield to the M.2
2230 mounting bracket.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
25