Service Manual
Table Of Contents
- Alienware m17 R4 Service Manual
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Alienware m17 R4
- Base cover
- Solid state drive—M.2 slot one
- Solid state drive—M.2 slot two
- Solid state drive—M.2 slot three
- Battery
- Speakers
- Keyboard-controller board
- Touchpad
- Rear-I/O cover
- Display assembly
- Right I/O-board
- System board
- Left I/O-board
- Fan and heat-sink assembly
- Power-adapter port
- Power-button assembly
- Keyboard
- Palmrest
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Alienware
About this task
The following image indicates the location of the speakers and provides a visual representation of the removal procedure.
Steps
1. Disconnect the speaker cable from the right I/O-board.
2. Lift the right speaker off the palm-rest assembly.
3. Remove the speaker cables from the routing guides on the palm-rest assembly.
4. Lift the left speaker off the palm-rest assembly.
Installing the speakers
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the speakers and provides a visual representation of the installation procedure.
30