Owner's Manual

Removing the Palm Rest Assembly | 65

7 Remove the power button board. See "Removing the Power Button Board" on

page 55.

8 Remove the display assembly. See "Removing the Display Assembly" on page 57.

9 Remove the status light board. See "Removing the Status Light Board" on page 61.

Procedure

1 Disconnect the touch pad cable, LVDS cable, and Media Card Reader cable from the

connectors on the system board.

2 Remove the screws that secure the palm rest assembly to the computer base.

3 Carefully pry out the palm rest assembly along the rear edge and then ease the palm

rest assembly from the computer base.

CAUTION: Carefully separate the palm rest assembly from the

computer base to avoid damage to the palm rest assembly.

4 Lift the palm rest assembly off the computer base.

1 palm rest assembly 2 LVDS cable

3 touch pad cable 4 Media Card Reader cable

5 screws (3)