Manual


1. Follow the instructions in Before You Begin.

2. Align the four captive screws on the processor heat-sink with the screw holes on the system board and tighten the screws in sequential order (indicated
on the processor heat-sink).

3. Replace the palm-rest assembly (see Replacing the Palm Rest).

4. Replace the display assembly (see Replacing the Display Assembly).

5. Replace the macro keyboard (see Replacing the Macro Keyboard).

6. Replace the keyboard (see Replacing the Keyboard).

7. Replace the center control cover (see Replacing the Center Control Cover).

8. Replace the base cover (see Replacing the Base Cover).

9. Replace the battery pack (see Replacing the Battery Pack).

Back to Contents Page

CAUTION: Incorrect alignment of the processor heat-sink can damage the processor.
NOTE: The original thermal grease can be reused if the original processor heat-sink is reinstalled. If the processor heat-sink is replaced, use the thermal
grease provided in the kit to ensure that thermal conductivity is achieved.
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.