Reference Guide
Table Of Contents
To enable replication on volumes, go to Storage >> Disks and right-click on the primary volume on which you want to enable
replication. Then follow these steps:
● Select Replication and click Enable
● Select the log volume for the primary site
● Select the Replica volume and associated log volume for the secondary site
● Overwrite the destination volume unless you have a seeded disk
● Select the mode of replication
● Complete the wizard
This enables replication on the volume after the initial block copy. The initial block copy process can take a few minutes to a few
hours, depending on the size of the volume.
Test-SRTopology
This cmdlet validates a potential replication partnership between source and destination computers. Follow these steps:
● Create a local CSVFS volume, for example 1 TB.
● Create a local log volume (ReFS), for example 50 GB.
● Create a Replica volume (ReFS), for example 1 TB (Ensure that the local and replica volumes are the same size).
● Create a Replica-log volume (ReFS), for example 50 GB.
###Step 1###
New-Volume -StoragePoolFriendlyName "Pool for Site Bangalore" -FriendlyName
'VolumeA' -FileSystem CSVFS_ReFS -Size 1TB
#Log Volume
New-Volume -StoragePoolFriendlyName "Pool for Site Bangalore" -FriendlyName
'VolumeA-Log' -FileSystem ReFS -Size 50GB
## Move 'Available Storage to Site B' ##
Get-ClusterGroup -Name 'Available Storage' | Get-ClusterResource | Stop-
ClusterResource
Move-ClusterGroup -Name 'Available Storage' -Node ax740xds2n1
###Step 2###
#Replica Volume
New-Volume -StoragePoolFriendlyName "Pool for Site Chennai" -FriendlyName
'VolumeA-Replica' -FileSystem ReFS -Size 1TB
#Replica Log Volume
New-Volume -StoragePoolFriendlyName "Pool for Site Chennai" -FriendlyName
'VolumeA-Replica-Log' -FileSystem ReFS -Size 50GB
###Step 3
# Create Replication Group for secondary volumes
$PathVolARep =Get-Volume -FriendlyName VolumeA-Replica | Select -
ExpandProperty Path
$PathVolARepLog=Get-Volume -FriendlyName VolumeA-Replica-Log | Select -
ExpandProperty Path
New-SRGroup -ComputerName ax740xds2n1 -Name Group108 -VolumeName $PathVolARep -
LogVolumeName $PathVolARepLog -LogSizeInBytes 2GB
Get-ClusterGroup -Name 'Available Storage' | Get-ClusterResource | Stop-
ClusterResource
Move-ClusterGroup -Name 'Available Storage' -Node ax740xds1n2
# Assign drive letters
Get-Volume -FriendlyName VolumeB-Log | Get-Partition | Set-Partition -
NewDriveLetter H
Get-Volume -FriendlyName VolumeB-Replica | Get-Partition | Set-Partition -
NewDriveLetter I
Get-Volume -FriendlyName VolumeB-Replica-Log | Get-Partition | Set-Partition -
NewDriveLetter J
Test-SRTopology -SourceComputerName ax740xds1n2 -SourceVolumeName
C:\ClusterStorage\VolumeB -SourceLogVolumeName H -DestinationComputerName
ax740xds2n1 -DestinationVolumeName I -DestinationLogVolumeName J -
DurationInMinutes 30 -ResultPath .\TopologyResults
The preceding cmdlet completes in 30 minutes and displays the results in HTML format.
24
Appendices