Installation manual

PowerConnect B-DCX-4S Mid-Mount Rack Kit Installation Procedure 3
53-1001798-01
In this guide
Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Installation guidelines . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Installing the DCX-4S in equipment cabinet. . . . . . . . . . . . . . . . . . . . . . . . . . 4
Unpacking the PowerConnect B-DCX-4S. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Install cabinet hardware . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Install DCX-4S in cabinet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Introduction
This document provides instructions to install a PowerConnect B-DCX-4S Backbone in a telecommunications (Telco)
cabinet.
Safety
Observe the caution notice in this manual. The caution notice has an ID, which is displayed in parentheses (C015).
Use this ID to locate the translation of this caution notice in the Brocade Product Safety Notices.
CAUTION
Use safe lifting practices when moving the product. (C015)
NOTE
A fully populated PowerConnect B-DCX-4S weighs 103.50 kg (228.20 lb) with four FC8-48 port cards installed (192
ports) and requires a hydraulic or assisted lift to install it.
Installation guidelines
ATTENTION
To ensure adequate cooling, install the chassis with the air intake (nonport side) facing the cool-air aisle.
Follow these general installation guidelines:
Provide a space that is 8 rack units (8U) high, 61.19 cm (24.09 in.) deep, and 43.74 cm (17.22 in.) wide. 1U is
equal to 4.45 cm (1.75 in.).
To allow the quick removal of all power from the chassis, use AC power sources that are easily accessible and
located near the chassis.
Verify that the additional weight of the chassis does not exceed the weight limits of the cabinet.