Installation manual

PowerConnect B-DCX-4S Mid-Mount Rack Kit Installation Procedure 7
53-1001798-01
FIGURE 2 Saddle installed in equipment cabinet.
NOTE
For rails with round holes, use the clip nuts (E in Figure 1 on page 5) on the cabinet rails for securing 10-32
screws. For rails with square holes, use the retainer nuts (F in Figure 1 on page 5). Also refer to Figure 3.
FIGURE 3 Using clip nuts and retainer nuts to secure screws to cabinet rails
3. Remove the existing rack-mount brackets (B and C in Figure 1 on page 5) from the DCX-4S chassis, and install
the new Telco mid-mount brackets from the accessory kit. Refer to Figure 4.