Installation manual

10 Port-Side Exhaust Kit Installation Procedure
53-1001802-01
FIGURE 5 Securing top rail in cabinet.
6. Secure the top-rail assembly to the cabinet with four 10-32 screws, two screws on each end of the top-rail
assembly.
• For rails with round holes:
Use two 10-32 screws with washers (E in Figure 1 on page 6) on each end of the top rail assembly. Tighten
screws according to specifications under “Torque requirements” on page 6.
• For rails with square holes:
Use the two standard 10-32 screws (D in Figure 1 on page 6) with blue Loctite on the threads and alignment
washers (H in Figure 1 on page 6) on each end of the top rail assembly. Tighten screws according to
specifications under “Torque requirements” on page 6.
Install DCX-4S in cabinet
1. Ensure that the door is removed from the port side of the DCX-4S. For instructions, refer to the corresponding
Hardware Reference Manual.
2. Use a lift to raise the chassis to the correct level.
CAUTION
Use safe lifting practices when moving the product. (C015)
3. If applicable, lock the wheels of the lift.
Install
screws
Install
screws
Install screws