Installation manual

14 Port-Side Exhaust Kit Installation Procedure

53-1001802-01

Install cabinet hardware

1. Determine how the DCX-4S can be oriented in the equipment cabinet so that the nonport side has access to

intake air (cool).

2. Install clip nuts (H in Figure 7 on page 13) or retainer nuts (I in Figure 7 on page 13) in cabinet rail locations

shown in Figure 8 on page 14. These nuts will secure the 10-32 screws that mount the Port Side Exhaust Kit

shelf and DCX-4S to the cabinet. For rails with round holes, use clip nuts. For rails with square holes, use

retainer nuts. Note that Figure 8 on page 14 shows relative positions for these nuts in the cabinet rails to mount

the shelf and DCX-4S. You may mount the shelf and DCX-4S in 9 U of cabinet space higher or lower in the

cabinet than shown.

FIGURE 8 Clip and retainer nut locations on cabinet rails

Setup for Rails

with Square Holes

Note

Screws, clip nuts, and retainer nuts

for DCX-4S are provided in the

DCX-4S hardware accessory kit.

Retainer Nut

(Item G)

Rail

Attaching Clip Nuts

for Round-Hole Rails

Clip or Retainer

Nut Locations

for DCX-4S

Clip or Retainer

Nut Locations

for Shelf