Installation manual

8 Port-Side Exhaust Kit Installation Procedure
53-1001802-01
3. Install the shelf (C in Figure 1):
a. The shelf can be adjusted to a length of between 27 and 31 inches (68.58 and 78.74 cm) to accommodate
your cabinet size. To lengthen or shorten the shelf, loosen the four 6-32 screws in the four slots on the shelf
(I-4 through I-7 in Figure 1 on page 6) and adjust the shelf to the desired length. Once adjusted, tighten the
four 6-32 screws.
b. Secure the shelf to the cabinet with eight 10-32 screws with washers (E in Figure 1 on page 6), two screws
in each corner of the shelf (see Figure 3). Tighten screws according to specifications under “Torque
requirements” on page 6.
FIGURE 3 Shelf installed in cabinet
4. Install the air-duct assembly by inserting it down into the side slot on the shelf. Ensure that the tabs of the duct
align and engage with the slots in the shelf.
Port Side
(Exhaust)