Operation Manual

66 Understanding the printer menus
Use To
Enable AutoIP Specify the Zero Configuration Networking setting.
Yes
Note: Yes is the factory default setting.
No
Enable FTP/TFTP Enable the built-in FTP server, which lets you send files to the printer using File Transfer
Protocol.
Yes
No Note: Yes is the factory default setting.
Enable HTTP Server Enable the built-in Web server (Embedded Web Server). When enabled, the printer
can be monitored and managed remotely using a Web browser.
Yes
No Note: Yes is the factory default setting.
WINS Server Address View or change the current WINS server address.
Enable DDNS View or change the current DDNS setting.
Yes
Note: Yes is the factory default setting.
No
Enable mDNS View or change the current mDNS setting.
Yes
Note: Yes is the factory default setting.
No
DNS Server Address View or change the current DNS server address.
Backup DNS Server Address View or change the backup DNS server addresses.
Backup DNS Server Address 2
Backup DNS Server Address 3
Enable HTTPS View or change the current HTTPS setting.
Yes
Note: Yes is the factory default setting.
No
IPv6 menu
To access the menu, navigate to any of the following:
• Network/Ports > Standard Network > Standard Network Setup > IPv6
• Network/Ports > Network [x] > Network [x] Setup > IPv6
Note: This menu is available only in network printers or printers connected to print servers.
Use To
Enable IPv6 Enable Internet Protocol Version Six (IPv6) in the printer.
On
IPv6 uses bigger numbers to create IP addresses.
Off
Note: On is the factory default setting.
Auto Configuration Specify whether or not the network adapter accepts the automatic IPv6
address configuration entries provided by a router.
On
Off Note: On is the factory default setting.
*
These settings can be changed only from the Embedded Web Server.