Operation Manual

69 Understanding the printer menus
Use To
USB Buffer Set the size of the USB input buffer.
Disabled
Notes:
Auto
• Auto is the factory default setting.
3K to [maximum size allowed]
• Disabled turns off job buffering.
• The USB buffer size value can be changed in 1-KB increments.
• The maximum size allowed depends on the amount of memory in the printer,
the size of the other link buffers, and whether Resource Save is set to On or
Off.
• To increase the maximum size range for USB Buffer, disable or reduce the size
of the parallel, serial, and network buffers.
• The printer automatically restarts when the setting is changed from the printer
control panel. The menu selection is then updated.
Mac Binary PS Set the printer to process Macintosh binary PostScript print jobs.
On
Notes:
Off
• Auto is the factory default setting.
Auto
• On processes raw binary PostScript print jobs.
• Off filters print jobs using the standard protocol.
ENA Address Set the network address information for an external print server.
yyy.yyy.yyy.yyy
Note: This menu is available only when the printer is attached to an external print
server through the USB port.
ENA Netmask Set the netmask information for an external print server.
yyy.yyy.yyy.yyy
Note: This menu is available only when the printer is attached to an external print
server through the USB port.
ENA Gateway Set the gateway information for an external print server.
yyy.yyy.yyy.yyy
Note: This menu is available only when the printer is attached to an external print
server through the USB port.
SMTP Setup menu
Use To
Primary SMTP Gateway Specify SMTP server gateway and port information.
Note: 25 is the default SMTP gateway port.
Primary SMTP Gateway Port
Secondary SMTP Gateway
Secondary SMTP Gateway Port
SMTP Timeout Specify the amount of time in seconds before the server stops trying to
5–30
send an e‑mail.
Note: 30 seconds is the factory default setting.
Reply Address Specify a reply address of up to 128 characters in the e-mail sent by the
printer.