Users Guide
Table Of Contents
- Table of Contents
- 1 Regulatory and Safety Approvals
- 2 Functional Description
- 3 Network Link and Activity Indication
- 4 Features
- 4.1 Software and Hardware Features
- 4.2 Virtualization Features
- 4.3 VXLAN
- 4.4 NVGRE/GRE/IP-in-IP/Geneve
- 4.5 Stateless Offloads
- 4.6 Priority Flow Control
- 4.7 Virtualization Offload
- 4.8 SR-IOV
- 4.9 Network Partitioning (NPAR)
- 4.10 Security
- 4.11 RDMA over Converged Ethernet – RoCE
- 4.12 VMWare Enhanced Networking Stack (ENS)
- 4.13 Supported Combinations
- 4.14 Unsupported Combinations
- 5 Installing the Hardware
- 6 Software Packages and Installation
- 7 Updating the Firmware
- 8 Link Aggregation
- 9 System-Level Configuration
- 10 PXE Boot
- 11 SR-IOV – Configuration and Use Case Examples
- 12 NPAR – Configuration and Use Case Example
- 13 Tunneling Configuration Examples
- 14 RoCE – Configuration and Use Case Examples
- 15 DCBX – Data Center Bridging
- 16 DPDK – Configuration and Use Case Examples
- Revision History
Broadcom NetXtreme-E-UG304-2CS
83
NetXtreme-E User Guide User Guide for Dell Platforms
10.3 PXE Boot with VLAN
To configure PXE boot with VLAN:
1. Set Virtual LAN Mode to Enabled and assign a valid Virtual LAN ID in the MBA Configuration menu.
2. Configure the PXE server interface with a matching VLAN ID.
NOTE: The Virtual LAN Mode and Virtual LAN ID parameters on the NIC Configuration menu is applicable to PXE boot
in UEFI mode as well. If Virtual LAN configuration is done from both the System Setup menus as well as the
adapter NIC Configuration menu, the Virtual LAN ID configured through System Setup takes precedence.
3. Trigger PXE on the adapter interface.
Comprehensive Configuration Management v218.0.14.0
Copyright (C) 2000-2019 Broadcom Limited
All rights reserved.
Allow port to be completely disabled by Host OS or driver command. Linux only
[ĸ:ĺ][Enter][Space]:Toggle Value;[ĹĻ]:Next Entry; [ESC]:Quit
Current Adapter:Primary, Bus=33 Device=00 Func=00, MAC=BC:97:E1:D3:2B:40
MBA Configuraiton Menu
Option ROM : Enabled
Boot Protocol : Preboot Execution Environment (PXE)
Boot Strap Type : Auto
Hide Setup Prompt : Disabled
Setup Key Stroke : Ctrl-S
Banner Message Timeout : 5 Seconds
Pre-boot Wake On LAN : Disabled
VLAN Mode : Enabled
VLAN ID : 1
Boot Retry Count : 0
Permit Total Port Shutdown : Disabled