User guide

User Guide NetXtreme II
September 2013
Broadcom Corporation
Document INGSRVT78-CDUM100-R iSCSI Offload in Windows Server Page 109
24 Error Target sent an iSCSI PDU with an invalid opcode. Dump data contains the entire iSCSI
header.
25 Error Data digest error was detected. Dump data contains the calculated checksum followed
by the given checksum.
26 Error Target trying to send more data than requested by the initiator.
27 Error Initiator could not find a match for the initiator task tag in the received PDU. Dump data
contains the entire iSCSI header.
28 Error Initiator received an invalid R2T packet. Dump data contains the entire iSCSI header.
29 Error Target rejected an iSCSI PDU sent by the initiator. Dump data contains the rejected
PDU.
30 Error Initiator could not allocate a work item for processing a request.
31 Error Initiator could not allocate resource for processing a request.
32 Information Initiator received an asynchronous logout message. The Target name is given in the
dump data.
33 Error Challenge size given by the target exceeds the maximum specified in iSCSI
specification.
34 Information A connection to the target was lost, but Initiator successfully reconnected to the target.
Dump data contains the target name.
35 Error Target CHAP secret is smaller than the minimum size (12 bytes) required by the
specification.
36 Error Initiator CHAP secret is smaller than the minimum size (12 bytes) required by the
specification. Dump data contains the given CHAP secret.
37 Error FIPS service could not be initialized. Persistent logons will not be processed.
38 Error Initiator requires CHAP for logon authentication, but target did not offer CHAP.
39 Error Initiator sent a task management command to reset the target. The target name is
given in the dump data.
40 Error Target requires logon authentication via CHAP, but Initiator is not configured to
perform CHAP.
41 Error Target did not send AuthMethod key during security negotiation phase.
42 Error Target sent an invalid status sequence number for a connection. Dump data contains
Expected Status Sequence number followed by the given status sequence number.
43 Error Target failed to respond in time for a login request.
44 Error Target failed to respond in time for a logout request.
45 Error Target failed to respond in time for a login request. This login request was for adding
a new connection to a session.
46 Error Target failed to respond in time for a SendTargets command.
47 Error Target failed to respond in time for a SCSI command sent through a WMI request.
48 Error Target failed to respond in time to a NOP request.
49 Error Target failed to respond in time to a Task Management request.
50 Error Target failed to respond in time to a Text Command sent to renegotiate iSCSI
parameters.
51 Error Target failed to respond in time to a logout request sent in response to an
asynchronous message from the target.
52 Error Initiator Service failed to respond in time to a request to configure IPSec resources for
an iSCSI connection.
Table 5: Offload iSCSI (OIS) Driver Event Log Messages
Message
Number
Severity Message