User guide

NetXtreme II User Guide
September 2013
Broadcom Corporation
Page 254 Managing the LAN Device Document INGSRVT78-CDUM100-R
BACScli -t <target type> -f <target format> -i <target ID> cablediag
Example:
1. The following command runs the cable diagnostics test for the current selected target.
BACScli -t PHYPORTS -f bdf -i 01:00.00 "cablediag"
In Interactive mode, use the list <view> and select <idx> commands to select the desired target device. Use the
cablediag command to run the cable analysis test for the selected target.
Example:
1. The following command runs the cable diagnostics test for the currently selected NDIS adapter.
cablediag
MANAGING THE LAN DEVICE
The LAN function represents the Ethernet (NDIS) functionality available under the PCI Function. User can view current
values of various NDIS driver parameters, configure NDIS driver parameters, view attached FCoE targets and LUN
information by selecting FCoE object in object explorer panel.
The available tabs for the NDIS function are as follows:
At the NDIS level, you can view parameters, configure parameters, and run tests from the following tabs:
• Information
• Configuration
• Diagnostics
• Statistics
VIEWING NDIS INFORMATION
Select the NDIS driver in the Explorer View pane, and then select the Information tab to view NDIS-level information.
NOTES:
• Information about Broadcom network adapters may be more comprehensive than information about network
adapters made by others.
• Some information may not be available for all Broadcom network adapters.
Viewing Driver Information
Information Tab: Driver Information