Messages Reference Guide

182 Fabric OS Message Reference
53-1002749-01
BM-1001
5
BM Messages
BM-1001
Message BM protocol version <Protocol version> in slot <Slot number>.
Message Type LOG
Severity ERROR
Probable Cause Indicates that the firmware running on the control processor (CP) cannot communicate with the
application processor (AP) blade in the indicated slot and determine the AP blade's firmware version.
The reason can be one of the following:
• The CP blade is running a later version of firmware than the AP blade.
• The CP blade is running an earlier version of firmware than the AP blade.
Recommended
Action
The problem can be corrected by changing the firmware version on either the CP or on the AP blade.
You can modify the firmware version on the CP blade by using the firmwareDownload command. Refer
to the release notes to determine whether a non-disruptive firmware download is supported between the
revisions. Because the AP and CP blades cannot communicate, it is not possible to load new firmware
on the AP blade. If necessary, send the AP blade back to the factory for a firmware update.
BM-1002
Message Connection established between CP and blade in slot <Slot number>.
Message Type LOG
Severity INFO
Probable Cause Indicates that the control processor (CP) has established a connection to the blade processor (BP) and
can communicate.
Recommended
Action
No action is required.
BM-1003
Message Failed to establish connection between CP and blade in slot <Slot number>.
Faulting blade.
Message Type LOG | FFDC
Severity WARNING
Probable Cause Indicates that the control processor (CP) could not establish a connection to the blade processor (BP) to
communicate.