Deployment Guide

Configuring zones on the switch
1. On the Select Zoning window (Figure 14 on page 28), select Typical Zoning.
If you want to use one of the other zone settings, refer to Editing the zoning configuration on page
55 for instructions on configuring Custom Zoning; refer to the Web Tools Administrator's Guide for
information on Advanced Zoning.
2. Click Next.
The Specify Devices window is displayed.
Specifying devices
On the Specify Devices window, complete the following steps.
1. Enter the number of HBA connections that you want to attach to the switch. Be sure to include
existing HBA connections, and any additional HBA connections you plan to make in the current
setup session. You can change this setting later if you want to add or remove HBA connections.
2. Enter the number of storage connections you want to attach to the switch. Be sure to include
existing storage connections, and any additional storage connections you plan to make in the
current setup session. You can change this setting later if you want to add or remove storage
connections.
Configuring zones on the switch
EZSwitchSetup Administrator’s Guide 29
53-1003129-01