Release Notes

Fabric OS v7.1.0a Release Notes v1.0 Page 19 of 41
Supported Switches
 Fabric OS v7.1 supports the Brocade 300, 5410/5424/5430/5450/5460/5470/5480/NC-
5480, 5100, 5300, VA-40FC, Brocade Encryption Switch (BES), DCX/DCX-4S, 8000, 7800,
6505, 6510, 6520, DCX 8510-8 and DCX 8510-4.
Access Gateway mode is also supported by Fabric OS v7.1, and is supported on the following switches: the
Brocade 300, 5100, VA-40FC, 8000, 5450, 5430, 5460, 5470, 5480, NC-5480, M5424, 6510, 6505.
Standards Compliance
This software conforms to the Fibre Channel Standards in a manner consistent with accepted
engineering practices and procedures. In certain cases, Brocade might add proprietary supplemental
functions to those specified in the standards. For a list of FC standards conformance, visit the
following Brocade Web site: http://www.brocade.com/sanstandards
The Brocade 8000 and FCOE10-24 blade conform to the following Ethernet standards:
 IEEE 802.1D Spanning Tree Protocol
 IEEE 802.1s Multiple Spanning Tree
 IEEE 802.1w Rapid reconfiguration of Spanning Tree Protocol
 IEEE 802.3ad Link Aggregation with LACP
 IEEE 802.3ae 10G Ethernet
 IEEE 802.1Q VLAN Tagging
 IEEE 802.1p Class of Service Prioritization and Tagging
 IEEE 802.1v VLAN Classification by Protocol and Port
 IEEE 802.1AB Link Layer Discovery Protocol (LLDP)
 IEEE 802.3x Flow Control (Pause Frames)
The following draft versions of the Converged Enhanced Ethernet (CEE) and Fibre Channel over Ethernet (FCoE)
Standards are also supported on the Brocade 8000 and FCOE10-24 blade:
 IEEE 802.1Qbb Priority-based Flow Control
 IEEE 802.1Qaz Enhanced Transmission Selection
 IEEE 802.1 DCB Capability Exchange Protocol (Proposed under the DCB Task Group of IEEE
802.1 Working Group)
 FC-BB-5 FCoE (Rev 2.0)
Technical Support
Contact your switch supplier for hardware, firmware, and software support, including product repairs and part
ordering. To expedite your call, have the following information immediately available:
1. General Information
 Technical Support contract number, if applicable
 Switch model
 Switch operating system version
 Error numbers and messages received
 supportSave command output and associated files
o For dual CP platforms running FOS v6.2 and above, the supportsave command gathers
information from both CPs and any AP blades installed in the chassis
 Detailed description of the problem, including the switch or fabric behavior immediately following
the problem, and specific questions