Service Manual

Fabric OS 7.4.0a Release Notes v2.0 Page 53 of 53
a. At the "Fabric parameters" prompt, type y.
b. At the "High Integrity Fabric Mode" prompt, type y.
If HIF configuration requirements have not been met, an error message describes what you must configure for
the command to succeed. For example, the following message states that an IDID, SCC policy or fabric-wide
consistency policy have not been configured for the switch. Perform additional configuration if required, then
enable HIF mode.
Error: Unable to set HIF Mode. No valid IDID settings, SCC policy and/or Fabric wide(SCC:S) configuration.