Deployment Guide
switch:admin> flow --show
------------------------------------------------------------------------------------------------
Flow Name |Feature| SrcDev | DstDev |IngrPt|EgrPt|BiDir|LUN|FrameType|SFID|DFID|MirPt|
------------------------------------------------------------------------------------------------
sys_gen_all_simports|gen |* |* |* |* |no |- |- |- |- |- |
fmtest |mir+ |010e00 |010f00 |14 |- |no |- |- |- |- |16 |
------------------------------------------------------------------------------------------------
+ Denotes feature is currently activated for the flow
The flow name with prefix sys_ denotes predefined flow
switch:admin> flow --show fmtest -feature mirror
================================================================================================
Name : fmtest Features: mir(Activated) noConfig: Off
Definition: IngrPort(14),SrcDev(0x010e00),DstDev(0x010f00),MirPort(16)
Flow Mirror (Activated):
------------------------------------------------------------------------------------------------
No of Mirrored Frames : 91134, No of RX Mirrored Frames : 91134, No of TX Mirrored Frames : 0
------------------------------------------------------------------------------------------------
================================================================================================
After a port is configured as a mirror port, the switchshow command output looks similar to the
following example:
switch:admin> switchshow|grep
Port
Index Port Address Media Speed State Proto
3 3 010300 id N16 Online FC G-Port
4 4 010400 id 16G Online FC SIM-Port 20:04:00:27:f8:93:6a:23
5 5 010500 id 16G Online FC SIM-Port 20:05:00:27:f8:93:6a:23
6 6 010600 id 16G Online FC SIM-Port 20:06:00:27:f8:93:6a:23
7 7 010700 id 16G Online FC SIM-Port 20:07:00:27:f8:93:6a:23
8 8 010800 id N8 Online FC G-Port
14 14 010e00 id N8 Online FC F-Port 50:08:01:60:09:15:7a:03
15 15 010f00 id N8 Online FC F-Port 50:08:01:60:09:15:7a:02
16 16 011000 id 8G Online FC Mirror Port<— Mirror port identification
After a port is configured as a mirror port, the portcfgshow command output looks similar to the
following example:
switch:admin> portcfgshow 16
Area Number: 16
Speed Level: AUTO(SW)
AL_PA Offset 13: OFF
Trunk Port ON
Long Distance OFF
VC Link Init OFF
Locked L_Port OFF
Locked G_Port OFF
Disabled E_Port OFF
Locked E_Port OFF
ISL R_RDY Mode OFF
RSCN Suppressed OFF
Persistent Disable OFF
LOS TOV enable OFF
NPIV capability ON
QOS Port AE
Port Auto Disable: OFF
Rate Limit OFF
EX Port OFF
Mirror Port ON <— Mirror port identification
SIM Port OFF
Credit Recovery ON
F_Port Buffers 32
E_Port Credits OFF
Fault Delay: 0(R_A_TOV)
NPIV PP Limit: 126
NPIV FLOGI Logout: OFF
CSCTL mode: OFF
D-Port mode: OFF
D-Port over DWDM: OFF
FEC: ON
FEC via TTS: OFF
Non-DFE: OFF
Flow Mirror
Flow Vision Administrators Guide 79
53-1003168-01