Deployment Guide

Fabric OS Command Reference 1095
53-1003131-01
supportShow
2
supportShow
Displays switch information for debugging purposes.
SYNOPSIS supportshow
supportshow slot[/port1-port2] [lines]
DESCRIPTION Use this command to display support information from groups of preselected Fabric OS and Linux
commands and other support and debugging information. You can specify a port or a range of ports for
which to display this information. These commands are organized by groups, but note that the order of
the groups listed below is not the same as executed by the command.
The FCIP commands are supported only on the Brocade 7800 switch and the Brocade FX8-24 blade. On
unsupported platforms, the command displays a "not applicable to this platform" message next to the
FCIP command group.
SupportShow executes commands in the following command groups. Use supportShowCfgenable or
supportShowCfgDisable to modify the settings for each group.
os
OS group commands, enabled by default.
exception
Exception group commands, enabled by default.
port
Port group commands, enabled by default.
fabric
Fabric group commands, enabled by default.
services
Service group commands, enabled by default.
security
Security group commands, enabled by default.
network
Network group commands, enabled by default.
portlog
Portlog group commands, enabled by default.
system
System group commands, enabled by default.
extend
Extend group commands, disabled by default.
filter
Filter group commands, disabled by default.
perfmon
Performance Monitor group commands, disabled by default.
ficon
FICON group commands, disabled by default.
iswitch
FC Router group commands, disabled by default.
asic_db
ASIC DB group commands, disabled by default.