Deployment Guide

Fabric OS Command Reference 145
53-1003131-01
configDownload
2
To download all system configuration data for the chassis and all logical switches (requires chassis
permissions):
switch:admin> configdownload -all -ftp 192.168.38.245, \
jdoe,config.txt,password
To download the switch configurations to a logical switch with FID 8 from an attached USB device
(requires chassis permissions):
switch:admin> configdownload -fid 8 -USB config.txt
To download the switch configurations belonging to a logical switch with FID 4 to a logical switch with FID
8 from an attached USB device (requires chassis permissions):
switch:admin> configdownload -fid 8 -sfid 4 \
-USB config_fid8.txt
To download the Virtual Fabric configuration file using secure FTP:
switch:admin> configdownload -vf -p sftp \
10.32.248.119,jdoe,/temp/switch-conf_66.txt,mypassword
To attempt to download the Virtual Fabric configuration interactively to a switch with configured Admin
Domains:
switch:admin> configdownload -vf -p sftp \
10.32.248.119,jdoe,/temp/switch-conf_66.txt,mypassword
*** CAUTION ***
This command is used to download the VF configuration to the
switch. Afterwards, the switch will be automatically rebooted
and the new VF settings will be used. You will then need to
run configdownload again to install the configuration(s) for
any logical switch(s) that are setup in the new VF configuration.
Please note that Virtual Fabrics and Admin Domains are mutually
exclusive and are not supported at the same time on a switch.
If any Admin Domains are configured on the switch, the
configdownload operation will fail.
Do you want to continue [y/n]: y
jdoe@10.32.248.119's password:
Error: configDownload operation failed. VF/AD Conflict detected.
Please remove all ADs before downloading the VF configuration to
the switch.
2011/06/12-17:14:02, [CONF-1023], 3637, FID 128, INFO, sw0,
configDownload failed for VF config parameters.
SEE ALSO configDefault, configList, configShow, configUpload, configure, configRemove